Arcade1Up Audio Amplifier Cable (Gen 3 and Newer)

Boost your audio with this simple plug and play amplifier cable.

When you replace the original PCB with an HDMI converter, audio is no longer amplified. This cable solves that by allowing your HDMI setup to properly power and boost the original speakers.

Designed for modded cabinets that use a 3.5 mm headphone jack for the speakers (Arcade1Up Gen 3 and newer, all known Basic Fun, and some Partycades).

Important: if your speakers use a JST connector, this is not the correct option.

Easy install. Plug your speaker’s 3.5 mm jack into this cable, then connect the other end to your HDMI converter.

Note: Our specialty audio cables work perfectly with Raspberry Pi setups. Some mini PCs, however, may have trouble sending audio through HDMI to the LCD converter board. If this happens, use an HDMI-to-DVI cable (HDMI into the mini PC, DVI into the converter board) and run an aux cable from the PC to the converter board. Use the left aux port on the bottom right of the board. Our cables will still function normally with this setup.